How do I fix errors in cmd?

0 Votes

The cmd error is the error that occurs while putting some command prompt to run the program. This error must be found and fixed to stop any disturbance. You should continue with this article without hesitation to grab the methods to fix the error. 

How to find errors in the cmd command?

You can find errors in CMD commands easily with the help of commands in the below-written bullet points. 

• First, you must type CMD (command prompt) in the start menu search bar, then tap run as administrator. 
• After that, type chkdsk and press enter. 
• Finally, the CHKDSK will scan for drive errors and notify you that it has found a drive or folder that has to be repaired, but you need to give a command to fix it. 

How do I fix errors in cmd?

You can fix errors in cmd with the help of Check Disk, which is basically a Windows built-in tool that checks your hard drive to find the corrupted files, then repairs bugs and errors, and cleans up disk space to maintain your PC’s health. 

• Chkdsk : you can scan the hard drive for bugs or errors with zero repair attempts. 
• Chkdsk [drive letter ]: replace [drive letter] to scan the particular internal and external drive.
• Chkdsk/f : you can attempt to fix bugs or errors while scanning the hard drive.
• Chkdsk/r : you can attempt to fix sectors on the hard drive to make it readable in the file system. 
• Chkdsk/x : you can disconnect a drive to scan and fix it.  
• Chkdsk/f/r/x : scans the file system and its sectors, then fixes if any error is found.

How to reset cmd? 

Sometimes you cannot log in through an account; then, you can start/restart your PC. Press and hold the power button until it shuts off.

• You can do this thrice; the next boot will load the Windows recovery environment. 
• Now go to Advanced options and select the troubleshooting option.
• After that, write the command C:\windows\system32 and click on enter.
• If you can log in, press Windows along with R and type cmd. Press ctrl + shift + enter to launch the command prompt as administrator cmd. 
• Now you can type system reset - factory reset on the command prompt and press enter. 
• At last, you will get options to keep your files or remove everything. 
• If you choose to keep my files, it will save everything inside the current user, which is the same as the username.
• If you choose the remove everything option, the system will delete everything, including your files. 
• Before resetting, you can check all the apps and finally click on the reset button to proceed with the factory reset. 

How do I clean up cmd? 

• Open CMD with admin id. 
• Then type cleanmgr into the CMD window and click on enter. 
• A small window on the panel will ask you to select the drive to clean up.
• At last, click on ok. 

You can rely on this article and complete the process for further doubts and queries.